Carbon fiber rods and tubes are manufactured by pulling or wrapping carbon fibers and epoxy resin to a desired diameter/cross section to form a densely reinforced carbon composite. MACHINING TIPS: To cut carbon fiber use an abrasive cutoff wheel or 32 teeth per inch hacksaw. Do not use a band saw.



CARBON FIBER RECTANGLE BAR

    Need a little help converting decimals to fractions? So do we. Click here or on the button on the left to convert this list to fractions or use our fraction conversion chart

See this category displayed in millimeters


Click on any item below to view and continue shopping:



Your Cart

Total: $0.00

View Cart